Skip navigation
Please use this identifier to cite or link to this item:
Full metadata record
DC FieldValueLanguage
dc.contributor.authorRana R.-
dc.contributor.authorChen S.-
dc.contributor.authorHaldar A.-
dc.contributor.authorDas, Sourav-
dc.identifier.citationArchives of Metallurgy and Materials (2017), 62(4): 2331-2338-
dc.description.abstractA carbide-free bainitic microstructure is suitable for achieving a combination of ultra high strength and high ductility. In this work, a steel containing nominally 0.34C-2Mn-1.5Si-1Cr (wt.%) was produced via industrial hot rolling and laboratory heat treatments. The austenitization (900°C, 30 min.) and austempering (300-400°C, 3 h) treatments were done in salt bath furnaces. The austempering treatments were designed to approximately simulate the coiling step, following hot rolling and run-out-table cooling, when the bainitic transformation would take place and certain amount of austenite would be stabilized due to suppression of carbide precipitation. The microstructures and various mechanical properties (tensile properties, bendability, flangeability, and room and subzero temperature impact toughness) relevant for applications were characterized. It was found that the mechanical properties were highly dependent on the stability of the retained austenite, presence of martensite in the microstructure and the size of the microstructural constituents. The highest amount of retained austenite (∼ 27 wt.%) was obtained in the sample austempered at 375°C but due to lower austenite stability and coarser overall microstructure, the sample exhibited lower tensile ductility, bendability, flangeability and impact toughness. The sample austempered at 400°C also showed poor properties due to the presence of initial martensite and coarse microstructure. The best combination of mechanical properties was achieved for the samples austempered at 325-350°C with a lower amount of retained austenite but with the highest mechanical stability. © 2017 R. Rana et al., published by De Gruyter Open 2017.-
dc.publisherDe Gruyter Open Ltd-
dc.relation.ispartofArchives of Metallurgy and Materials-
dc.subjectCarbide-Free Bainite-
dc.subjectHot Rolling-
dc.subjectMechanical Properties-
dc.subjectRetained Austenite-
dc.titleMechanical properties of a bainitic steel producible by hot rolling-
dc.affiliationRana, R., Tata Steel, Wenckebachstraat 1, Ijmuiden, 1970 Ca, Netherlands-
dc.affiliationChen, S., Tata Steel, Wenckebachstraat 1, Ijmuiden, 1970 Ca, Netherlands-
dc.affiliationHaldar, A., Tata Steel, Moorgate Road, Rotherham, S60 3AR, United Kingdom-
dc.affiliationDas, S., IIT Roorkee, Uttarakhand, 247667, India-
dc.description.correspondingauthorRana, R.; Tata Steel, Wenckebachstraat 1, Netherlands; email:
Appears in Collections:Journal Publications [MT]

Files in This Item:
There are no files associated with this item.
Show simple item record

Items in Repository are protected by copyright, with all rights reserved, unless otherwise indicated.